Sub-Zero $model.subName Manual do Utilizador descarregar pdf (Página 41)

As the reveal between cabinets and the

Integrated unit decreases, the potential

exists for severe finger pinching or crushing

if a hand or fingers are placed in the

opening when the door is closing.

When 19 mm or thicker panels are used

and a reveal less than 6 mm is maintained,

the door panels may cause damage to the

Sub-Zero unit when the door is open at the

maximum 105˚ stop. You should use the

built-in 90˚ stop to prevent damage.

681 mm 681 mm

DOOR

SUB-ZERO

UNIT

DOOR

SUB-ZERO

UNIT

1372 mm

TO BACK

OF UNIT

REVEAL

*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL

CABINETRY

OR SIDE

PANEL

CABINETRY

OR SIDE

PANEL

635 mm

610

3 mm* min 3 mm* min

19 mm

PA NE L 19 mm PA NE L

3 mm* min

DOOR

SUB-ZERO

UNIT

DOOR

SUB-ZERO

UNIT

1829 mm

TO BACK

OF UNIT

*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL

CABINETRY

OR SIDE

PANEL

CABINETRY

OR SIDE

PANEL

910 mm 910 mm

635 mm 635 mm

REVEAL

3 mm* min

REVEAL

3 mm* min

REVEAL

3 mm* min

19 mm

PA NE L19 mm PA NE L

610 mm

914 mm

WIDE MODELS

Panel width dimen-

sions for installation

of two 914 mm wide

tall units side by

side.

Dimensions are based

on a 3 mm reveal. A

reveal of up to 6 mm

is possible, but panel

dimensions need to be

adjusted accordingly.

686 mm

WIDE MODELS

Panel width dimen-

sions for installation

of two 686 mm wide

tall units side by

side.

Dimensions are based

on a 3 mm reveal. A

reveal of up to 6 mm

is possible, but panel

dimensions need to be

adjusted accordingly.

PANEL

REQUIREMENTS

Door and drawer

panels must be a

minimum of 16 mm

thick.

The door panel

cannot exceed 18 kg

and each drawer

panel must not

exceed 5 kg for 686

mm wide units. For

914 mm wide units,

the door panel

weight limit is 24 kg

and 7 kg for each

drawer panel.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

Comentários a estes Manuais

Sem comentários

Sub-Zero $model.subName Manual do Utilizador Página 41

Comentários a estes Manuais

Manuais e produtos relacionados com não Sub-Zero $model.subName